capasse.ch

Will it fit?

Compare your current wheels with the ones you're considering: capasse.ch works out to the millimetre what changes under the arch, by the suspension and on the speedometer.

Compare my setupFree, no account needed.

What it's for

  • New wheels

  • Different tyres

  • Adding spacers

  • Checking your setup

Your comparison

How would you like to start?

Fitments taken from the approval data published by FEDRO (ASTRA). If your model is missing, enter your sizes.

You can also enter the type approval number from field 24 of your Swiss vehicle registration document: the search is then exact.

Source: Federal Roads Office (FEDRO/ASTRA), type approvals and eDatenblatt.

Where do I find my sizes?
On the tyre sidewall
255/45 R20 103Y
Width, aspect ratio, diameter, then load and speed ratings.
On the wheel
8.5J x 20 ET45
On the back of a spoke or inside the barrel: width, diameter and offset.
On the vehicle label
In the driver's door frame or the fuel flap: the factory sizes.

Current setup

The one on your car today.

Front
Sizes to complete

Front

Wheel
Tyre

Tyre diameter: same as the wheel.

The rear uses the same values as the front.

Expert mode

Bolt pattern, centre bore and ratings: to check the wheel fits the hub and the tyre carries enough load.

Front

New setup

The one you are considering.

Front
Sizes to complete

Front

Wheel
Tyre

Tyre diameter: same as the wheel.

The rear uses the same values as the front.

Expert mode

Bolt pattern, centre bore and ratings: to check the wheel fits the hub and the tyre carries enough load.

Front

What it gives

Fill in both setups: the differences appear here as soon as the fields are complete.

Results are indicative geometric calculations. Real clearance depends in particular on the wheel design, brake calipers, suspension, bodywork, camber, load and the actual tyre dimensions. Geometric compatibility is not a type approval.

Wheel and tyre fitment calculator: FAQ

capasse.ch is a free wheel and tyre fitment calculator built for Switzerland. Compare two setups (wheel width and diameter, ET or offset, spacer, tyre size) and see straight away what changes under the arch, on the suspension side, on the speedometer and in track width.

How do I know if new wheels will fit my car?

Enter your current setup and the one you are considering. Since your current wheels fit, they are the reference: the calculator shows how much closer the new ones come to the suspension, how far they stick out towards the arch and how the diameter changes. Only a test fit confirms it, because brake calipers, suspension and bodywork vary from car to car.

What is wheel offset (ET)?

Offset (ET, from the German Einpresstiefe) is the distance in millimetres between the wheel's mounting face on the hub and the centre line of the wheel. A lower offset moves the wheel outwards, towards the arch; a higher offset pulls it in, towards the suspension. A 10 mm spacer equals 10 mm less offset.

How do I calculate tyre diameter?

For a 225/45 R18: sidewall height 225 × 45% = 101.25 mm, overall diameter 18 × 25.4 + 2 × 101.25 = 659.7 mm. The calculator does this for both setups and shows the difference in millimetres and as a percentage.

Does a bigger tyre change my speedometer reading?

Yes: with a larger diameter the wheel covers more ground per turn, so you drive faster than the speedometer shows; a smaller diameter does the opposite. The “Actual speed” table shows the difference from 30 to 130 km/h, assuming the speedometer is accurate with your current setup.

Is my new setup allowed in Switzerland?

Setups listed in your vehicle's type approval or certificate of conformity are intended for it. Pick your vehicle in the search, or enter the type approval number from field 24 of your Swiss vehicle registration document: capasse.ch checks whether your new setup is listed. For anything else, check with your canton's road traffic office.

Where do I find my wheel and tyre sizes?

On the tyre sidewall (for example 225/45 R18 94Y), on the back of a spoke or inside the wheel barrel (for example 8J × 18 ET45) and, for the factory sizes, on the label in the driver's door frame or fuel flap.

Why can overall width shrink even with a lower offset?

Track width at the tyre centre depends only on offset. But if the new tyre is much narrower, its outer sidewalls can still move inwards. capasse.ch shows both: the overall width, outer sidewall to outer sidewall, and the track at the tyre centre.